
Sterling Heights Roof Pros provides professional attic & roof ventilation in Sterling Heights, MI for residential and commercial properties across central Macomb County. Ventilation is the page where our recommendation most often runs opposite to what a homeowner has been told, because on a standard truss roof the problem is nearly always intake and the standard sales answer is more exhaust.
Here is the geometry. A conventional truss sits on the top plate with a heel only a few inches deep, so the roof plane is very close to the ceiling plane at the eave. Blow twelve or sixteen inches of loose fill into that attic and the insulation reaches the sheathing and chokes the soffit before the installer even notices. The vents are there. Air is not moving through them.
Add a long ridge vent to that attic and you have created a chimney with no bottom. It still pulls, but it pulls its makeup air from inside the house, through can lights, bath fan boots, the top plates of interior partitions and the attic hatch. You get higher heating bills and more moisture in the attic than before, which is the opposite of the intended result.
So we correct intake first. Rigid baffles at every truss bay at the heel, holding a clear channel from the soffit up past the insulation line. Blocked or painted-over soffit panels replaced with genuinely vented aluminum. Insulation dammed back off the baffle. Only then do we size exhaust, and we size it to the intake we actually achieved, not to the roof area.
We also chase the air leaks, because ventilation cannot outrun a hole. Bath fans terminating into the attic instead of through the roof are the single most common thing we find in this housing stock. Recessed lights without airtight cans are second. Sealing those does more for attic frost than any vent product on the market. Both are a morning's work and both cost less than the vent product.
If you already have gable vents and someone wants to add ridge vent, be careful. Running both can short-circuit the flow so that the ridge draws from the gable instead of from the eave, and the far end of the attic stops ventilating entirely. Sometimes the right answer is to block the gables. Sometimes it is to leave the ridge alone. It depends on what your intake will actually deliver, which is a measurement rather than an opinion.
Our licensed and insured team brings the right materials and equipment to every job — metal truss connector plates, Fink truss webs, heel bearing over the exterior top plate, raised-heel energy trusses, H-clips between roof sheathing panels, seven-sixteenths OSB roof decking — and backs the work with a written workmanship warranty. We serve Sterling Heights and nearby communities including Utica, Shelby Township, Clinton Township, Macomb Township.
What We Handle
Everything our attic & roof ventilation in Sterling Heights covers
One crew, one point of contact, and the full range of attic & roof ventilation work in Sterling Heights, MI. If it is on this list we do it in house rather than handing it to a subcontractor:
- roof ventilation Sterling Heights
- attic ventilation balance
- soffit intake baffles
- ridge vent installation
- net free area calculation
- attic frost condensation Michigan
- blocked soffit vents
- raised heel truss ventilation
- gable vent conversion
- bath fan venting attic
- attic insulation and airflow
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Sterling Heights services.
Materials, equipment and how we do attic & roof ventilation
The difference between attic & roof ventilation that lasts and attic & roof ventilation that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with metal truss connector plates, Fink truss webs, heel bearing over the exterior top plate, raised-heel energy trusses, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Sterling Heights job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in central Macomb County means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do attic & roof ventilation outside Sterling Heights
Sterling Heights Roof Pros covers Sterling Heights and the surrounding communities of central Macomb County. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Attic & Roof Ventilation in Utica, MI — Macomb County, population 5,245
- Attic & Roof Ventilation in Shelby Township, MI — Macomb County, population 79,408
- Attic & Roof Ventilation in Clinton Township, MI — Macomb County, population 100,513
- Attic & Roof Ventilation in Macomb Township, MI — Macomb County, population 91,663
- Attic & Roof Ventilation in Mount Clemens, MI — Macomb County, population 15,697
- Attic & Roof Ventilation in Harrison Township, MI — Macomb County, population 24,314
Start on the Sterling Heights Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Sterling Heights Chooses Sterling Heights Roof Pros
- ✓We photograph every metal connector plate and heel bearing in your attic and hand you the file, hired or not
- ✓Full tear-off only on truss-framed homes, because a second layer hides the frame and adds load it was never drawn for
- ✓Intake ventilation is corrected before any exhaust is added, so a starved attic is not made worse
- ✓We name the finished roof dead load in the quote and compare it to what the original builder specified
The standards behind attic & roof ventilation
Quality here is not a matter of opinion — it is written down. The attic & roof ventilation work we do in Sterling Heights follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every attic & roof ventilation project in Sterling Heights gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free attic & roof ventilation free estimate in Sterling Heights, or request a quote and we'll get right back to you.